Something not working, Problem, Possible cause – Zanussi FL 726 CN User Manual
Page 18: The machine does not start up, The machine does not fill, The machine does not empty and/or does not spin, There is water on the floor, Unsatisfactory washing results, The machine fills then empties immediately

18
SOMETHING NOT WORKING
n
Problem
n
Possible cause
n
The machine does not start up:
n
Check that the door is firmly closed.
n
Check that the machine is plugged in and
that there is power at the socket.
n
Check that the main fuse has not blown.
n
Check that the programme selector dial is
positioned correctly and pulled out.
n
The machine does not fill:
n
Check that the water tap is open.
n
Check that water is coming out of the tap.
n
Check that the inlet hose is not squashed or
kinked.
n
Check that the filter in the inlet hose is not
blocked.
n
Check that the door is closed.
n
The machine does not empty
and/or does not spin:
n
Check that the drain hose is not squashed or
kinked.
n
The anticrease
option has been selected.
n
The laundry is not evenly distributed in the
drum.
n
There is water on the floor:
n
Too much detergent or unsuitable detergent
(creates too much foam) has been used.
n
Check whether there are any leaks from one
of the inlet hose fittings. It is not always easy
to see this as the water runs down the hose;
check to see if it is damp.
n
Check that the drain hose is not damaged.
n
Unsatisfactory washing results:
n
Too little detergent or unsuitable detergent
has been used.
n
Stubborn stains have not been treated prior
to washing.
n
The correct temperature or programme was
not selected.
n
The machine fills then empties
immediately:
n
The end of the drain hose is too low. Refer to
relevant paragraph in “water drainage”
section.
Problems which you can resolve yourself