Electrolux EDH3498RDL - Manual (Page 10)

6. SETTINGS
A
D
B
C
E
I
J
F G H
A) Time touchpad
B)
Delay touchpad
C)
Buzzer touchpad
D) Anticrease touchpad
E)
Start/Pause touchpad
F) Rack Time increase touchpad
G) Rack Time decrease touchpad
H) MyFavourite+ touchpad
I) Reverse Plus touchpad
J)
Dryness touchpad
6.1 Child lock function
This option prevents children to play with
the appliance while a programme oper-
ates. The programme knob and the
touchpads are locked. Only the on/off
button is unlocked.
Activating the child lock option
1. Press the on/off button to activate the
appliance.
2. Press and hold touchpads (A) and (D)
at the same time until the child lock in-
dicator comes on.
• It is possible to deactivate the child
lock option while a programme op-
erates. Press and hold the same
touchpads until the child lock indi-
cator goes off.
6.2 Language
Setting the language
1. Press and hold touchpads (B) and (C)
at the same time until previously selec-
ted language comes on.
2. Press the or touchpad to set
your language.
To memorise the selection press the E
touchpad.
6.3 Water hardness and
conductivity
Water hardness is different for different lo-
cations. Water hardness has an effect on
the water conductivity and on the con-
ductivity sensor of the appliance. If you
know, the value of the water conductivity
you can adjust the sensor in order to have
better drying results.
Adjusting the conductivity sensor
1. Press the on/off button to activate the
appliance
2. Press and hold touchpads (A) and (B)
at the same time until one of the these
indicators comes on:
•
(low <300 μS/cm)
• (moderate 300-600 μS/cm)
•
(high >600 μS/cm)
3. Press the touchpad (E) again and
again until the indicator of the correct
level comes on.
4. To confirm the adjustment, press and
hold touchpads (A) and (B) at the
same time for approximately 2 sec-
onds.
6.4 The indicator of the water
container
By default, the indicator of the water con-
tainer is on. It comes on when the pro-
gramme is completed or when it is neces-
sary to empty the water container.
If the “Draining kit” is installed, the
appliance automatically drains the
water from the water container. In
this condition we recommend that
you deactivate the indicator of the
water container.
Refer to the supplied leaflet for
available accessories.
Deactivating the water container
indicator
1. Press the on/off button to activate the
appliance
2. Press and hold touchpads (J) and (I)
at the same time until the display
shows one of these 2 configurations:
10 www.electrolux.com