Electrolux ESL6552RA - Manual (Page 28)

7. DAILY USE
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to ’SET-
TING AND STARTING A PRO-
GRAMME’.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme
for the type of load and the degree of
soil.
7.1 Using the detergent
20
30
M AX
1 2 3 4
+ -
A B
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
7.2 Setting and starting a
programme
Setting mode
The appliance must be in setting mode for
some operations.
Press the on/off button to activate the ap-
pliance.
• The appliance is in setting mode if the
display shows, intermittently, the num-
ber and the duration of the last pro-
gramme.
• The appliance is not in setting mode if
the display shows only the duration of
the programme.
– Press and hold buttons (4) and (5) at
the same time until the appliance is in
setting mode.
The Auto Off function
To decrease the energy consumption, this
function automatically deactivates the ap-
pliance after a few minutes when:
• You have not closed the door to start
the programme.
• The programme is completed.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode.
3. Press the Program button again and
again until the display shows the num-
ber of the programme you want to set.
Refer to the programme table.
• The display shows intermittently the
number and the duration of the pro-
gramme.
4. If you want, you can set the options
that are applicable to the programme.
Refer to the programme table.
5. Close the appliance door. The pro-
gramme starts.
• If you open the door, the display
shows the programme duration.
Starting a programme with delay
start
1. Set the programme.
28 www.electrolux.com