Electrolux ESL6552RA - Manual (Page 25)

How to activate the TimeSaver option
1. Press the TimeSaver button.
• If the option is applicable to the pro-
gramme, the related indicator
comes on. In the display you can
see the update of the programme
duration.
• If the option is not applicable to the
programme, the related indicator
does not come on.
5.3 Multitab
Activate this option only when you use the
combi detergent tablets.
This option deactivates the use of rinse
aid and salt. The related indicators stay
off.
The programme duration can increase.
How to activate the Multitab option
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to ‘SET-
TING AND STARTING A PRO-
GRAMME'.
2. Press the Multitab button, the related
indicator comes on.
The option stays on until you deactivate it.
Press the Multitab button, the related in-
dicator goes off.
If you stop to use the combi
detergent tablets, before you start to
use separately detergent, rinse aid
and dishwasher salt, do these steps:
1. Deactivate the Multitab option.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse
aid.
5.4 EnergySaver
This option decreases the temperature in
the last rinse phase.
The use of this option decreases the ener-
gy consumption (up to 25%) and the pro-
gramme duration.
The dishes can be wet at the end of the
programme.
How to activate the EnergySaver
option
1. Press the EnergySaver button.
• If the option is applicable to the pro-
gramme, the related indicator
comes on. In the display you can
see the update of the programme
duration.
• If the option is not applicable to the
programme, the related indicator
does not come on.
5.5 Acoustic signals
The acoustic signals operate when the
appliance has a malfunction or when the
adjustment of the level of the water soft-
ener occurs. It is not possible to deacti-
vate these acoustic signals.
There is also an acoustic signal that oper-
ates when the programme is completed.
By default, this acoustic signal is off but it
is possible to activate it.
How to activate the acoustic signal
for the end of programme
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to ‘SET-
TING AND STARTING A PRO-
GRAMME’.
2. Press and hold buttons (4) and (5) at
the same time until the indicators of
buttons (3), (4) and (5) flash.
3. Press button (5),
• The indicators of buttons (3) and (4)
go off.
• The indicator of button (5) continues
to flash.
• The display shows the current set-
ting.
Acoustic signal on
Acoustic signal off
4. Press button (5) to change the setting.
5. Deactivate the appliance to confirm
the setting.
ENGLISH 25