Electrolux EFC90244X - Manual (Page 18)

18 18 18 18 18 electr electr electr electr electrolux olux olux olux olux installation
GB
• •• •• Apply flues support bracket to the wall
touching the ceiling. Use the flues
support bracket as a perforation dia-
gram (the small slot in the support
must coincide with the line previously
drawn on the wall, if present), and
mark two holes with a pencil. Make
the holes and insert 2 dowels.
• •• •• Fix the flues support bracket to the
wall with 2 screws. Fig.4 Fig.4 Fig.4 Fig.4 Fig.4
Fig.4 Fig.4 Fig.4 Fig.4 Fig.4
G
Ш 8
Ш 5x45
• •• •• Hang the hood to the two upper
screws.
• •• •• Introduce and screw the screws (and
washer(s)) up into the hole(s) for the
definitive fixing (COMPULSOR COMPULSOR COMPULSOR COMPULSOR COMPULSORY!! Y!! Y!! Y!! Y!!).
Then, having checked the setting of
the hood, TIGHTEN ALL THE upper
and lower SCREWS. Fig.5
Fig.5 Fig.5 Fig.5 Fig.5
Note: Note: Note: Note: Note: the lower fixing points are vis-
ible removing the fats filters and they
are at the sides and/or at the centre
of the hood (after having removed the
frame of the carbon filter, if present,
in the latter case).
In any case, we recommend using
the lateral holes, when available, to
increase the stability of the hood.
Fig.5 Fig.5 Fig.5 Fig.5 Fig.5