Electrolux EWG127410W - Manual (Page 19)

Problem Possible cause/Solution
The machine vibrates or is noisy:
The transit bolts and packing have not been re-
moved.
• Check the correct installation of the appli-
ance.
The support feet have not been adjusted
• Check the correct levelling of the appliance.
The laundry is not evenly distributed in the
drum.
• Redistribute the laundry.
Maybe there is very little laundry in the drum.
• Load more laundry.
Spinning starts late or the machine does not
spin:
The electronic unbalance detection device has
cut in because the laundry is not evenly distrib-
uted in the drum. The laundry is redistributed by
reverse rotation of the drum. This may happen
several times before the unbalance disappears
and normal spinning can resume. If, after some
minutes, the laundry is still not evenly distributed
in the drum, the machine will not spin.
• Redistribute the laundry.
The machine makes an unusual noise:
The machine is fitted with a type of motor which
makes an unusual noise compared with other
traditional motors. This new motor ensures a
softer start and more even distribution of the
laundry in the drum when spinning, as well as
increased stability of the machine.
No water is visible in the drum:
Machines based on modern technology operate
very economically using very little water without
affecting performance.
If you are unable to identify or solve the
problem, contact our service centre. Before
telephoning, make a note of the model, se-
rial number and purchase date of your ma-
chine: the Service Centre will require this
information.
Mod. ... ... ...
Prod. No. ... ... ...
Ser. No. ...
TECHNICAL DATA
Dimensions Width / Height / Depth 60 / 85 / 54 mm
Electrical connection Voltage
Overall power
Fuse
Frequency 220-230 V
2000 W
10 A
50 Hz
Water supply pressure Minimum
Maximum 0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Level of protection against ingress of solid particles and moisture IPX4
Water supply 1) Cold water
Maximum Load Cotton 7 kg
electrolux 19