Electrolux EIDW6405HT - Manual (Page 8)

8 Operating Instructions
STATUS WINDOW
NOTE
Opening the door during normal operation will
only pause the selected cycle.
Start/Cancel
To start a cycle, press the START touchpad once
and close the door. To cancel when a cycle is
running, open the door and press the CANCEL
touchpad once. Close the door again and the
dishwasher will drain and shut off.
Error Indications
In certain situations which are critical to the ma-
chine function and safe operation, the control shall
shut down and indicate an error code “Er” (See
Error Codes on page 21).
If one of these codes are displayed contact the
Electrolux Customer Care Center at
1-877-435-
3287 . They will be able to provide assistance in
troubleshooting the problem and/or locating an
authorized service technician, if needed.
When BLUE LIGHT luminates on the floor this
indicates that the wash cycle is complete.
BLUE LIGHT
CHIME
These models are equipped with a chime to audibly
indicate when you have pressed a cycle or
selected an option.
1 HR-24HRS Indicates number of delay start
hours for selected cycle.
Cd Displayed once the program has
been entered, the START/
CANCEL touchpad is pressed
and after a 10 second delay. It
also flashes if the door is
opened during a wash cycle,
after a 10 second delay.
Close the dishwasher door to
begin or continue a wash
cycle.
SA Displayed when SANITIZE
option has been selected,
dishwasher has reached
SANITIZE temperature at
completion of wash cycle. SA
will remain displayed for 10
seconds.
The STATUS window displays codes typically seen
during programming of the dishwasher. The window
will not display anything when the door is closed.
The STATUS window indicates the following activity:
CL Displayed when wash cycle has
been completed, SANITIZE has not
been selected or SANITIZE
temperature has not been
reached. CL will remain displayed
for 10 seconds.