Setting self-clean cycle, Setting self-clean, Setting delayed self-clean – Electrolux EW30GS75KS User Manual
Page 45: Important
45
Setting self-clean
The clean feature provides 3 different choices for
self-cleaning the lower oven. Set the clean for
lite
(2 hrs),
med (3 hrs) or heavy soils (4 hrs). The
example below shows setting the lower oven for
self-clean to begin immediately using a medium (3
hour) setting:
Setting delayed self-clean
You may wish to set your appliance to perform a
self-clean cycle sometime later (up to 12 hours
later). The
END TIME key will determine when the
cleaning will stop.
You will need to set the
END TIME out far enough
to allow for the type of clean cycle you choose
(2-3-4 hours). Remember to add 30-40 additional
minutes for the oven to cool enough and the oven
door to unlock.
The example below shows setting the upper oven
for a lite (2 hour) self-clean cycle to end at 8:00
o’clock:
After pressing start, the motorized oven door latch
will automatically lock the door. The DOOR lock
icon will flash (Fig. 1). Once the door has locked
the DOOR lock icon will remain on through the
entire self-clean cycle.
After self-clean, the oven may take about 30-40
minutes to cool and unlock. A
Hot message (Fig.
2) will display during this period. During cooling the
DOOR lock icon will flash and disappear indicating
that the door has unlocked.
Fig. 2
Fig. 1
Example
Step
Press
1. Remove racks and supports
and press
UPPER OVEN
UPPER
OVEN
2. Press
ClEAN
3. Select
MED or
select lite or heavy
4. Press
START
Example
Step
Press
1. Remove racks and
press
UPPER OVEN
UPPER
OVEN
2. Press
ClEAN
3. Select
lITE
4. Press
COOK OPTIONS
5. Press
END TIME
6. Enter
800
7. Press
START
Setting Self-Clean Cycle
NOTE
You may press CANCEL any time during the
cleaning process. After cancelling the self-clean
cycle, do not attempt to open the oven door until
the DOOR lock icon turns off.
IMPORTANT
• A self-clean cycle will not start if the appliance
has the CONTROL LOCK turned on.
• If a self-clean cycle was started but did not
finish due to a power failure, your oven may
not be completely cleaned. After power
has been restored and the oven door has
unlocked, set for another self-clean if needed.