Electrolux EIDW5705PW - Manual (Page 7)

7
Operating Instructions
STATUS INDICATOR LIGHTS
When the SANITIZE option is selected, the
SANITIZED light will glow when the SANITIZE cycle
is finished and remain on for 30 seconds after the
door is opened. If the dishwasher did not properly
sanitize the dishes, the light will not come on. This
can happen if the cycle is interrupted or if incoming
water temperature is below 120
o F.
NOTE
The wash cycle time could suddenly increase or
drop several minutes. This means the Smart
Sensor has checked the soil level and
determined if additional water fills are needed or
if water fills can be deleted.
NOTE
Lights and Display on top of console will shut off
when the door is closed. They will light up when
the door is opened and display time remaining
will be displaye for several seconds. Then “Cd”
will display flashing, informing you to close the
door so the cycle can continue.
PF........ Appears in window when
dishwasher is first
installed, or when power
has been interrupted. HI-
TEMP WASH and NO HEAT
DRY indicator lights will
also flash. To clear, touch
START/CANCEL pad.
1H-24H... Number of delay start
hours. Count down are in
hours.
Cd......... Close dishwasher door.
The status indicator lights
will also flash to indicate
current cycle status.
Minutes..... Number of minutes left in
cycle (1-200).
The CLEAN light will come on at the end of the
cycle. When the door is opened at end of cycle
and remain on for 30 seconds after door is opened.
Error Indications
In certain situations which are critical to the ma-
chine function and safe operation, the control shall
shut down and indicate an error code ‘Er’, or ‘CE’
(See Error Codes).
If one of these codes are displayed contact the
Electrolux Customer Care Center at
1-877-435-
3287 . They will be able to provide assistance in
troubleshooting the problem and/or locating an
authorized service technician, if needed.