Electrolux EIDW5705PW - Manual (Page 12)

12
Factors Affecting Performance
WATER PRESSURE
The hot water line to the dishwasher must provide
water pressure between 20 and 120 pounds per
square inch (psi).
Low water pressure may occur when laundry or
showers are in operation. Wait until water use is
reduced before starting dishwasher.
WATER TEMPERATURE
Hot water is needed for best dishwashing and drying
results. Water entering the dishwasher should be at
least 120°F (49°C) to give satisfactory results.
To check water temperature entering
the dishwasher:
1 Turn on hot water faucet nearest dishwasher
for several minutes to clear cool water from
pipes.
2 Hold a candy or meat thermometer in stream
of water to check the temperature.
3 If temperature is below 120°F (49°C), have a
qualified person raise the water heater
thermostat setting.
IMPORTANT
Before starting a cycle, run hot water to clear
cool water from pipe.
The HEAT DRY option in combination with rinse aid
will enhance drying performance. The energy
required to use the HEAT DRY option costs pennies
per cycle. You may choose not to select the HEAT
DRY option; however you will have items in your dish
load that will not be completely dry at the end of the
cycle.
RINSE AID
Rinse aid greatly improves drying and reduces
water spots and filming. Water "sheets" off
dishes rather than forming water droplets that cling
and leave spots.
A dispenser, located next to the detergent cup,
automatically releases a measured amount of rinse
aid during the last rinse. If spotting and poor drying
are problems, increase the amount of rinse aid
dispensed by rotating the dial to a higher number.
The dial is located under the dispenser cap. The
indicator will be dark when full and will show clear
when it is time to refill. On models with a STATUS
window, LO will appear at the end of the cycle
indicating that it is time to refill.
To add liquid rinse aid, turn dispenser cap 1/4 turn
counterclockwise and lift out. Pour in rinse aid until
liquid touches the indicated fill level. Replace cap.
Do not overfill since this can cause oversudsing.
Wipe up any spills with a damp cloth.
The dispenser holds enough for 35 to 140 washes,
depending on setting.
Adjustable setting
Dispenser Opening
Dispenser Cap
Indicator
More Less