beautypg.com

Air filter and luxury design™ lighting, Pure advantage™ air filter, Luxury design™ lighting – Electrolux EI32AR65JS User Manual

Page 13

background image

13

Air Filter and Luxury Design™ Lighting

Pure Advantage™ Air Filter

Your new Pure Advantage air fi lter is located inside one of the 2 Liter Door Bins. The air fi lter cover is located on
the upper right side of the control box. In general, you should change the air fi lter with Part Number “EAFCBF”
every six months to ensure optimal fi ltering of freezer odors. The replacement air fi lter can be purchased
on the Electrolux website (http://www.electroluxappliances.com) or call toll free in the U.S. and Canada:
1-877-4ELECTROLUX (1-877-435-3287). Your electronic control is equipped with a Change Filter Indicator to
remind you to change your fi lter. See page 10.

To Install Or Replace The Air Filter

Pull down on the front of the Pure Advantage™ air filter cover. This releases the hinged bottom cover to
drop open.

Remove the old fi lter and discard it.

Unpackage the new fi lter and place it inside the hinged bottom cover of the housing.

Push the hinged bottom cover upward until the tab snaps into closed position.

air filter

reset

press & hold

r

r

temp

mode

alarm

off

control

lock

Air Filter

Open Air Filter Cover

Remove Air Filter

Luxury Design™ Lighting

The interior cabinet lighting features LED lights that
gradually ramp up in intensity after the door is opened.

To replace an LED:

1. Unplug the electrical cord or switch OFF the

power supply breaker.

2. Push down on the LED cover and then pull away

from the cabinet interior.

3. From the inside of the LED cover, remove the

wire harness connector by pressing on the latch
with a small fl at bladed screwdriver. Pull the wire
harness connector out of the LED.

4. Replace with a new LED and install in the reverse

order.

Remove Wire

Harness

Connection

Push on

Underside of

Connector to

Release Latch

Unplug the unit or switch the breaker that
supplies power to the unit to the off position
before changing an LED light.