Electrolux EI24ID30QS - Manual (Page 4)

4 Feature Overview
H o w y o u r d i s h w a s h e r c l e a n s
Your dishwasher cleans by spraying a mixture of hot water and detergent through the spray arms against
soiled surfaces. First, the dishwasher drains for a few seconds to remove soils dropped while loading,
then fills with water covering the filter area. Water is then pumped through the spray arms. Soil particles
go through and across the filter and down the drain as the water is pumped out. This series of steps are
repeated as needed. The number of water fills varies with the cycle being used.
G e t t i n g S t a r t e d
To run your dishwasher, follow these basic steps:
1. Load Dishwasher (See Preparing and Loading Dishes).
2. Add detergent (See Dishwasher Dispenser & Detergents).
3. Add Rinse Aid, if needed (See Rinse Aid).
4. Select desired CYCLE (See Cycle Chart).
5. Select desired OPTION (See Energy Options).
6. Run hot water faucet nearest dishwasher until water is hot. Turn water off.
7. To start, press START pad and close door.
Upper Spray Arm
Flex Wash
Silverware Basket
Filters
Serial Label
(located on right
side of door)
Tub Gasket
Cup Shelves
Middle Spray
Arm
Bottom Rack
Lower Spray
Arm
Detergent
Dispenser
Rinse Aid
Dispenser
Upper Rack