Electrolux EI36EC45KB - Manual (Page 11)

11 Radiant Element Controls
Sabbath feature mode
This appliance provides special settings for use
when observing the Jewish Sabbath/Holidays. This
mode will turn off all audible tones or visual display
changes normally provided by the cooktop controls.
When the Sabbath feature is ON, “Sb” will be showed
on the Minute Timer display and the zones will show
“H”. All zones ON and the main ON indicators will
be active. The Timer feature is locked and it is
not allowed to activate a cooktop element during
Sabbath mode. The element has to be activated
prior to Sabbath mode entry.
To activate the Sabbath Feature Mode:
Touch and hold simultaneously the “-” key of the
Minute Timer Control and the “lock” key. After a few
seconds, “H” will be shown on the zone displays and
“Sb” on the Minute Timer Control.
To change power setting when the Sabbath
Feature is active:
It is allowed to adjust the power setting of an active
cooktop element during Sabbath mode. During the
adjustment the control does not provide visual or
audible feedback, display show “H”. Once adjusted,
the new power setting takes effect after a random
delay from 15 to 30 seconds.
To turn OFF the cooktop element when the
Sabbath Feature is active:
Proceed as usual but take note that the element
will immediately turn OFF without any delay. The
“on” indicator will stay illuminated when the element
turns OFF.
To deactivate the Sabbath Feature Mode:
Touch and hold simultaneously the “-” key of the
Minute Timer Control and the “lock” key. When
Sabbath mode is deactivated, the unit turns OFF.
Sabbath Failure mode:
If a power failure occurs during Sabbath mode,
“SF” will appear in the minute displays when the
power comes back up. All radiant elements will turn
OFF. To return to normal operation, deactivate the
Sabbath Mode.
Fault Condition:
If a fault condition occurs during Sabbath, power will
be immediately removed from all heating elements.
The display will show the error code while the control
will produce an error tone until the fault condition is
removed or the On/Off key is touched. If the On/Off
key is touched after the fault condition is removed,
the control will be in the Failure Sabbath mode as
described above.
+