Electrolux EI27BS26JS - Manual (Page 32)

32 Care and Cleaning
Care and cleaning tips
Part
Cleaning
Agents
Tips and Precautions
Interior & Door
Liners
• Soap and
water
• Baking soda
and water
• Use two (2) tablespoons of baking soda in one (1) quart of warm water.
• Be sure to wring excess water out of sponge or cloth before cleaning around
controls, light bulb or any electrical part.
Door Gaskets • Soap and
water
• Wipe gaskets with a clean soft cloth.
Drawers &
Bins
• Soap and
water
• Use a soft cloth to clean drawer runners and tracks.
• Do not wash any removable items (bins, drawers, etc.) in dishwasher.
Glass Shelves • Soap and
water
• Glass cleaner
• Mild liquid
sprays
• Allow glass to warm to room temperature before immersing in warm water. Sudden
temperature changes can cause glass breakage.
Toe Grille • Soap and
water
• Mild liquid
sprays
• Vacuum
• Remove toe grille (see Installation Instructions).
• Vacuum both sides and wipe with sudsy cloth or sponge. Rinse and dry.
Exterior &
Handles
• Soap and
water
• Non abrasive
glass cleaner
• Do not use commercial household cleaners containing ammonia, bleach or alcohol
to clean handles.
• Use a soft cloth to clean smooth handles.
• Do not use a dry cloth to clean smooth doors.
Exterior &
Handles
(Stainless
Steel Models
Only)
• Soap and
water
• Stainless steel
cleaners
• Never use CHLORIDE or cleaners with bleach to clean stainless steel.
• Clean stainless steel front and handles with non-abrasive soapy water and a
dishcloth. Rinse with clean water and a soft cloth.
• Use a non-abrasive stainless steel cleaner. These cleaners can be purchased at
most home improvement or major department stores. Always follow manufacturer’s
instruction. Do not use household cleaners containing ammonia or bleach.
• NOTE: Always clean, wipe and dry with grain to prevent scratching.
• Wash the rest of the cabinet with warm water and mild liquid detergent. Rinse well
and wipe dry with a clean soft cloth.
Ice Chute Extension
The ice chute extension is
designed to better direct ice
flow into containers.
Push Upward Until The
Extension Snaps In Place
Pull Down
Press Here
Firmly
Removing the Ice
Chute Extension For Cleaning
1 Turn the refrigerator off using the button on the
control panel (refer
to Owner’s Manual).
2 Press inward firmly
on the front of the
chute and pull
down.
3 Turn your
refrigerator back on.
Installing the Ice
Chute Extension
1 Turn the refrigerator
off using the button on
the control panel (refer
to Owner’s Manual).
2 Align the extension
with the ice chute so
that the snap clips are
just inside the front
edge of the chute.
3 Push upward until the extension snaps into place.
4 Turn your refrigerator back on.