Auto Page RF-502 - Manual (Page 8)

RF-502
6
Approach the vehicle and press the ON/OFF remote transmitter button.
The siren will chirp 2 times and the lights will flash to indicate the RF-
502 is disarmed.
G. AUTOMATIC RE-ARMING
The RF-502 is equipped with an automatic re-arming circuit that will
return the alarm to a fully armed state if a door is not opened within 60
seconds after disarming. This automatic re-arming circuit can be
eliminated at the time of installation.
H.
BREACH WARNING
The RF-502 is equipped with BREACH WARNING to tell you, upon
disarming, if the alarm has been triggered in your absence. Press the
ON/OFF button on the remote transmitter. If a breach has occurred, the
siren will signal with 4 chirps, the lights will flash four times, and the
LED will be flashing in a 2 second flash/hold sequence.
I. IGNITION CONTROL POWER DOOR LOCK SYSTEM
When installed with remote power door locks, the vehicle's doors will
automatically lock when the ignition is switched on. The doors will
automatically unlock when the ignition is switched off. In order to avoid
any undesirable lock-out, the doors will not lock if any door is left open.
This feature is optional at time of installation. If the ignition control door
lock system is not chosen, the doors will not lock in passive arming.
However, the doors will lock in manual arming and automatic re-arming.
J. TRIGGER TEST
After arming the RF-502 in either the PASSIVE or MANUAL mode, test
the system in the following manner.