Auto Page RF-502 - Manual (Page 7)

RF-502
5
E. PASSIVE/MANUAL ARMING OPERATION
(Optional at installation)
Passive/Manual operations can be selectable if an optional toggle
switch is installed. Consult your installing dealer.
1. PASSIVE ARMING
If you choose the PASSIVE (automatic) mode, the system must be
operated as below.
1. Switch OFF vehicle ignition, exit vehicle, and be sure all protected
openings are closed.
2. The LED STATUS INDICATOR will begin fast flashing and the
passive arming timer will begin counting down.
3. If you re-open the exit the LED will stop flashing.
4. Close the exit, and the LED will start flashing again.
5. The RF-502 will count down for 30 seconds. After 30 seconds,
the siren will chirp 1 time indicating the RF-502 has armed.
NOTE: If the optional remote power door locks feature is installed, the
doors will automatically lock 10 seconds after the PASSIVE arming cycle
is completed. This feature is available only if the ignition control power
door lock system is selected.
2. MANUAL ARMING
If you choose the MANUAL (active) arming mode, follow the steps below.
1. Switch off ignition, leave vehicle, and close all protected openings.
2. Press the ON/OFF button on the remote transmitter.
3. The siren will chirp 1 time. 5 seconds later the RF-502 will be fully
armed.
F. PASSIVE/MANUAL DISARMING OPERATION