Brother DS-600 - Manual (Page 26)

Windows ® Operation
8
1
INSTALLING HARDWARE
Do not connect the scanner to your computer until instructed to do so by the driver installation software. When
instructed to do so, connect the scanner cable as shown below and follow the instructions.
After you have installed the software, follow the steps below. Then, proceed to Calibration.
a Connect the USB cable to the scanner and to a USB port on your computer as shown below (either to a
desktop or laptop computer). If necessary, please check your computer’s user guide to identify the USB
ports available and their locations.
b
The following message will be displayed, and the computer will automatically detect the new hardware
device installed and it will be ready for use.