Aquatic SYMPHONY SERIES - Manual (Page 15)

aquatic Industries, Inc. 1
installation instructions
1. Remove all construction residue and foreign materials. Wipe unit clean with a damp rag, otherwise staining may
occur.
2. Plaster may be removed by scraping with the edge of a piece of wood or rigid plastic. Do not use metal scraper.
For spots left by plaster or grout: rub lightly with a liquid detergent (Spic and Span or similar) on damp cloth or
sponge.
3. Do not use abrasive cleaners, scouring powders, steel wool, wire brushes or anything else that may harm or dull
the surface.
4. Paint, tar, or stubborn stains may be removed with rubbing alcohol. To avoid discoloration, cleaners containing
petroleum distillates must not remain on surfaces. NEvER use lacquer thinner or chlorinated solvents.
5. Dulled areas can be restored to a high gloss with white or a non-abrasive automotive rubbing compound, followed
by application of carnauba wax or white or cream automotive paste wax and buffing.
6. Remove minor scratches with 600 grit wet/dry sandpaper, followed by use of automotive rubbing compound and
paste wax, as above.
7. Major gouges require professional repair. Contact supplier to arrange factory-authorized repair services.
clean-uP:
systeM test:
1. Fill clean tub with water to a point no less than 2” above the highest jet, dirt left in tub may cause staining.
2. To test the ground Fault Circuit Interrupter (gFCI), push the test button. The gFCI should interrupt power. Push
the reset button. Power should be restored. If the gFCI fails to operate in this manner, there is a ground current
flowing, indicating the possibility of an electric shock. Do not use this unit. Disconnect the unit and have the problem
corrected by a licensed electrician before using.
3. Push on/off button on the whirlpool unit.
4. Allow system to run a full 10-minutes.
5. Through access door or removable skirt, check for leaks in whirlpool plumbing system. Make sure half-unions at
both ends of pump are hand-tight. If leakage is occurring at any other points, notify distributor.
6. if any electrical malfunctions occur, consult electrician. Malfunctions of the pump/motor, whirlpool controls or
the circulating system should be reported to the distributor who supplied the whirlpool tub.