beautypg.com

Removal and refitting of brake drum – ArvinMeritor MERITOR TE9000 User Manual

Page 18

background image

18

TE9000 / 93000 Service

The hubodometer is best assembled with the hub cap off the axle. Place
the hub cap on a clean, flat surface. Fit the nut to spanner (fig. 25) and
using a small amount of grease locate the washer on the nut.

Position the nut and washer under the mounting hole using the spanner
and lower the hubodometer through the hole to engage the thread. Rotate
the hubodometer to screw the nut along the mounting stud until hand tight
then tighten with the spanner in the normal way. The hub cap and gasket
can then be refitted to the axle as described in section 22.

For hubodometer types larger than 85mm outside diameter, use
hubodometer mounting plate 21222610.

Fit the hubodometer to the centre hole of the mounting plate. Remove
three of the five hub cap fixing screws from the hub end to suit the bracket
fixing bolt hole pattern. Offer the hubodometer bracket to the front face of
the standard hub cap and replace the three fixing screws as described in
section 22.

A range of hubodometers are available to suit various tyre sizes as shown
in fig. 26.

REMOVAL AND REFITTING OF BRAKE DRUM

The brake drum can be separated from the hub after removal of the road
wheel as follows. Remove the two countersunk drum retaining screws
from the drum flange face using a 10mm Allen key (fig. 27).

These screws can then be used to jack the drum free of its locating
spigots by refitting them to the two plain tapped holes in the drum flange
ensuring they are tightened evenly to prevent the drum tipping (fig. 28).

The drum can then be lifted clear of the hub.

To refit the brake drum, locate it over the wheel studs ensuring it is
correctly orientated to align the two countersunk retaining bolt holes with
the tapped holes in the hub. Refit the two retaining screws and tighten to
50/60 Nm ensuring that the drum is fully seated on its locating spigot.
Ensure the retaining screw heads are below the surface of the brake drum
flange face after tightening.

Part Number

Tyre Size

Kilometres

Miles

15R22.5

21212648

21212649

F20 PILOTE

21206207

12.00 x 20

18 x 22.5

21021019

16.5 x 22.5

21204639

21021018

11.00 x 20

21023810

21021016

12.00 x 22.5

10.00 x 20

21022758

21021015

11.00 x 22.5
10.00 x 22.5

21023732

21021014

9.00 x 20
8.25 x 20

21021013

FIG. 26

FIG. 25

FIG. 27

FIG. 28

This manual is related to the following products: