AT&T AT3111-2 - Manual (Page 14)

Telephone operation
10
To program a pause:
1. Press
MENU/
SELECT
from the idle mode.
2. Press CID or to select >VOICEMAIL SETUP
then press
MENU
/SELECT twice.
3. The blinking cursor should be at the end of
your access number. Press and hold the
REDIAL
/PAUSE button until a P appears.
4. Press
MENU
/SELECT. You will hear a
confirmation tone.
To reset all voicemail codes:
1. Press
MENU/
SELECT
from the idle mode.
2. Press CID or to select >VOICEMAIL SETUP
then press
MENU
/SELECT.
3. Press CID or to select >RESET ALL CODES,
then press
MENU
/SELECT.
4. The screen displays RESET CODES?
5. Press
MENU
/SELECT. You will hear a
confirmation tone.
Handset settings
NOTE: A single pause
(approximately three
seconds) is
automatically
programmed between
the access number and
the password when you
program your
VOICEMAIL button so
that your voicemail
service will recognize
your password.
Depending on your
voicemail service, you
may need to program
an extra pause between
the access number and
your password.