82 chapter 4: motherboard info, P4p8t sata connectors sata2, Sata1 – Asus Terminator 2 Barebone System T2-P User Manual
Page 82: P4p8t ide connectors, Sec_ide, Pri_ide

82
Chapter 4: Motherboard info
P4P8T
®
P4P8T SATA Connectors
SATA2
GND
RSA
T
A_TXP2
RSA
T
A_TXN2
GND
RSA
T
A_RXP2
RSA
T
A_RXN2
GND
SATA1
GND
RSA
T
A_TXP1
RSA
T
A_TXN1
GND
RSA
T
A_RXP1
RSA
T
A_RXN1
GND
10. Serial ATA connectors (7-pin SATA2, SATA1)
These next generation connectors support the thin Serial ATA cables
for Serial ATA hard disks. The current Serial ATA interface allows up
to 150 MB/s data transfer rate, faster than the standard parallel ATA
with 133MB/s (Ultra ATA133).
9.
IDE connectors (40-1 pin PRI_IDE, SEC_IDE)
The PRI_IDE connector is for the UltraATA100 IDE hard disk ribbon
cable. Connect the cable’s blue connector to the IDE connector, then
connect the gray connector to a slave device (optical drive) and the
black connector to the UltraATA100 master device (hard disk drive).
Refer to the hard disk documentation for the jumper settings.
Pin 20 on the IDE connector is removed to match the covered hole on
the UltraATA cable connector. This prevents incorrect orientation when
you connect the cables.
For UltraATA133 IDE devices, use an 80-conductor IDE cable.
P4P8T
®
P4P8T IDE Connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
SEC_IDE
PIN 1
PRI_IDE