UEi Test Instruments DT302 - Manual (Page 14)

Starting and Stopping Logging
Memory clear, and PC communications are in accessible during logging.
Recall function is enabled during logging.
1. Set the time and the logging interval, see “ How to Change
Setup Options ”.
2. Press “ “ momentarily to start logging. The display
shows “ LOG “.
3. Press “ “ momentarily again to stop logging.
Clearing Memory
When memory is full, “ “ appears in the secondary display and
logging stops. You can clear memory in normal or MIN/MAX mode.
1. Press “ “ for more than 1 second to display “ “ in the
“RECALL” mode.
2. Press “ “ for more than 1 second again to delete all logged
readings from memory.
3. Press “ “ momentarily or turn off the thermometer to stop
clearing memory.
Viewing Logged Readings
1. Press “ “ momentarily to display the last logged reading. If
there is no logged readings, “ “ appears in the secondary
display, and the thermometer returns to the previous mode.
2. Press “ “ to scroll through the logged readings. The display
shows each logged reading and its time stamp, which is
displayed 2 seconds after its memory location appeared in the
secondary display.
3. Press “ “ momentarily to step through the minimum,
maximum, average, and currently logged reading.
4. (DT302) Press “ “ momentarily to display the logged readings
you want to view. Press “ “ for more than 1 second to display
differential values between the logged readings you want to view.
12