UEi Test Instruments SMART BELL PLUS KIT - Manual (Page 4)

a
Nalyzer
c
oNNectioNS
NOTE: Take care when inserting the temperature
probes as the pins are polarized. Insert with the smaller pin into input
marked positive. (+)
WARNING!
Turning the pump off while the probe is in the flue
will leave toxic gases inside the analyzer. Once data
has been read, it is advisable to purge the
unit with fresh air as soon as possible. To do this,
with the probe removed from the flue, turn ON the
pump. Always allow the readings to return to zero
(0.0 for CO2) prior to shutting the unit off.
WARNING!
The probe will be hot from flue gases. Remove the probe from the flue and allow it to cool naturally. Do
not immerse the probe in water, as this will be drawn into the analyzer and damage the pump and sensors. Once the
probe is removed from the flue and the readings have returned to ambient levels rotate the selector
to “OFF”. The instrument will count down from 30 to switch off.
f
iNiShiNG
u
p
• Remove the probe from the flue and allow the analyzer to purge with fresh air until readings return to zero.
- CO2 to 0.0%, CO to Zero (Be careful as the probe tip will be HOT)
• Drain water trap
• Check particle filter
• Rotate selector to “OFF”
NOTE: To protect the sensor “HIGH” will be displayed and the zero countdown will repeat until
CO measured is less than 20 ppm.
S
mart
B
ell
pluS o
verview
OFF
L
Oi
l
Pro
pane
Nat Gas
H Oil
W
oo
d
St
an
db
y
CO
CO2
O2 X-Air
T Flu
e
Ef
f
˚F /
˚C
˚C ˚F 0000
LCD Display
Selector
Dial
Water
Trap
Fuel/Test Type
Indicator
2