Agri-Fab 45-03261 - Manual (Page 6)

6
5/16" x 1-3/4"
CARRIAGE BOLT (C)
5/16" NYLOCK NUT (J)
4
5. Cut off the plastic tie that holds the height adjustment
tube in place.
6. (Figure 4) Assemble the R.H. hitch tube to the sweeper
housing using two 5/16" x 1-3/4" carriage bolts (C), and
two 5/16" nylock nuts (J).
Do not tighten yet. Repeat
for the L.H. hitch tube.
7. (Figure 5) Fasten the hitch tubes together using two
5/16" x 3" hex bolts (A) and 5/16" nylock nuts (J).
Do
not tighten yet.
5
5/16" x 3"
HEX BOLT (A)
5/16"
NYLOCK NUT (J)
3. (Figure 3) Attach the brush assembly with the black
brush retainer to the left end of the brush shaft using
two 1/4" x 1" hex bolts (G) and 1/4" nylock nuts (I). The
brush retainer marked with black ink must be placed to
the
middle of the sweeper.
4. (Figure 3) Turn a wheel to rotate the brushes. (The
wheels drive the brushes in one direction only.) The
overlap bristles should be on the back side of the brush
as it rotates.
3
1/4" x 1"
HEX BOLT (G)
1/4" NYLOCK NUT (I)
BRUSH RETAINER
MARKED BLACK
ENGLISH