Takagi T-D2-IN/OS - Manual (Page 2)

T-D2-IN
The Manufacturer reserves the right to change or discontinue the design, drawing and/or specification of its products without notice at any time.
Flow Rate vs. Temperature Rise
Pressure Loss
Flo
w R
at
e (g
pm)
Temperature Rise ( ° F)
Pr
essur
e L
oss (psi)
Head F
eet
Installation Type
Electric Consumption
Fuel
NG LP
Min 11,000 BTU/h Min 11,000 BTU/h
Max 199,000 BTU/h Max 199,000 BTU/h
Energy Factor 0.83 0.82
Min 5.0" W.C. Min 8.0" W.C.
Max 10.5" W.C. Max 14.0" W.C.
Flow Rate Max 10.0 GPM
40 psi or above recommended for maximum flow
Without Remote (Dipswitch Setting) 104°F, 113°F, 122°F (Default), 131°F, 140°F, 158°F,
176°F, and 185°F
With TM-RE30 Temperature Remote
Controller : 99°F to 185°F,
122°F Default Factory Setting
99°F, 100°F, 102°F, 104°F, 106°F, 108°F, 109°F, 110°F,
111°F, 113°F, 115°F, 117°F, 122°F (Default), 131°F,
140°F, 158°F, 167°F, 176°F, and 185°F Temperature Settings
Indoor and Direct Vent Only
120 VAC ; Standby: 0.05 A, Operation: 0.75 A, Freeze-Protection: 0.93 A
Gas Consumption Input
Inlet Gas Pressure
Water Pressure 15-150 psi
Pressure Only Relief Valve Required
(Min 200,000 BTUs. 150 psi)
0
20
40
60
80
100
120
0
10
20
30
40
50
60
70
80
0.0 2.0 4.0 6.0 8.0 10.0 12.0
Set Temperature : 122 ° F & lower
Set Temperature: 131 ° F & higher
Flow Rate ( gpm )
0.0
1.0
2.0
3.0
4.0
5.0
6.0
7.0
8.0
9.0
10.0
11.0
12.0
0 20 40 60 80 100 120 140