ProMariner TruePower 200-400 - Manual (Page 6)

4
F e a t u r e s / I n s t a l l a t i o n G u i d e l i n e s
15
S p e c i f i c a t i o n s
Specifications
TruePower 200W 400W
Power (W) 200W 400W
Continuous Power 200W 400W
Surge Power 400W 800W
Output Waveform Modified Sine Wave
AC Output voltage 115V +/- 10%
AC Output amps (up to) 1.8A 3.6A
DC Input Voltage 10V to 15V +/-.5v
DC Input Amps (up to) 20A 40A
Efficiency >85%
No load current <0.3A <0.6A
Cooling Fan No Yes
Short Protection Yes Yes
Soft- Start Yes
High Voltage Protection Yes
Low Battery Alarm (Bat’ Saver) 11.9VDC
Low Battery Shutdown (Bat’ Saver) 11.7VDC
Low battery Alarm 10.5VDC +/- .5VDC
Low Battery Shutdown 10VDC +/- .5VDC
Reverse Polarity Protection (By Fuse) Yes
Operating environment temperature -15 to 50° Celsius or 5 to 122° Fahrenheit
External Fuse 25A 40A
Recommended User Supplied 25A 40A
ABYC E-11 Compliant Fuse
ProMariner Part No. for Recommended
User Supplied ABYC E-11 Compliant Fuse
Amperage 5 - 70 amps 30 amp 40 amp
AGU Fuses for TruePower Models
88103 88530 88540
Single Position
AGU Fuse Holder
AGU Fuse
for 400w
AGU Fuse
for 200w
Inverter Features
The TruePower inverter comes standard with a Ground Fault Circuit Interrupter
(GFCI) protected Dual AC outlet which can protect the user against hazardous
electrical shock that could be caused by dampness, water spray, or worn cables.
Bat’ Saver- mode allows the user to protect from draining down the entire power of
the engine start battery, and shuts the inverter off when the battery reaches a threshold
of 11.7 volts allowing you to still start your boat or vehicle.
Soft Start, Noise Filtered Technology- progressively increases the output voltage to
start heavy loads, with minimal or no interference.
TruePower performance features include:
- Internal Conformal Coating for Anti-Corrosion
- Soft Start and Noise Filtered Technology
- Bat’ Saver Mode – 200 to 1200 watt Models
- True Rated Continuous Power
- Hi-Surge Ratings for Demanding Loads
- Heavy Duty Marine/Industrial Construction
- Constructed to UL 458
- Meets the Requirements of ABYC E-11 Marine
- Highly Visible Power & Fault LED Indicators
TruePower Inverters are protected by a variety of features including:
- GFCI AC Outlet Safety Protected
- Input Polarity Protection
- Low Battery Alarm
- Low Battery Shutdown
- Overload Protection
- Output Short Circuit Protection
- Thermal Protection
- Over Voltage (15 VDC) Protection
Note: These inverters may not be suitable for use with some fluorescent lighting, halogen lights or
other inductive loads. If you wish to run such an item, plug it in to one of the inverter outlets and plug
in a small non-inductive load bearing item such as a low wattage light bulb into the other outlet.
Mounting your Inverter
IMPORTANT: ALWAYS PLACE THE INVERTER IN AN ENVIRONMENT WHICH IS:
(A) WELL VENTILATED
(B) NOT EXPOSED TO DIRECT SUNLIGHT OR HEAT SOURCE
(C) OUT OF REACH FROM CHILDREN
(D) AWAY FROM WATER / MOISTURE, OIL OR GREASE
(E) AWAY FROM ANY FLAMMABLE SUBSTANCE
(F) DO NOT INSTALL DIRECTLY ABOVE OR BELOW BATTERIES