ProMariner ProTournament - Manual (Page 6)

ProTournament Charger vs. Leading Traditional Linear Charger
4
Distributed On-Demand ™ 3 Step Charging Output
ProMariner's Distributed On-Demand ™
Charging technology ensures 100% of
the ProTournament 300's 30 amps is fully
utilized. The 8 amps not required by the
engine start battery is automatically
Distributed On-Demand
™ to trolling motor
batteries #1 and #2.
Engine
Start Battery 3
14 14 2
Trolling
Battery 2
Trolling
Battery 1
Bank No. 1 Bank No. 2 Bank No. 3
+ +
30 Amps Fully Distributed
10 Lbs.
10 10 2
Engine
Start Battery 3
Trolling
Battery 2
Trolling
Battery 1
Bank No. 1 Bank No. 2 Bank No. 3
+ +
Up to 10 Amps per Bank
(10/10/10)
22 Lbs.
Competitive chargers have an amp
limitation per bank as illustrated. The
30 amp (10/10/10) charger only delivers
22 amps. The 8 amps not used by the
engine start battery can not be shifted
to battery #1 or battery #2.
Note: Above illustration reflects typical battery usage after a day of fishing.
Trolling motor batteries are 50% discharged and not usable. Engine start battery
is 80% charged from the engine charging system.
Typical Leading Competitive Charging Output
P r o To u r n a m e n t O v e r v i e w
ProTournament's "Distributed On-Demand ™ Charging" will automatically distribute its full
rated output of 10, 15, 20 or 30 amps (model specific) to any one bank or combination of
all battery banks. ProTournament distributes and uses every charging amp with no waste
unlike other 2 and 3 bank chargers with an amp limit per bank.
11
M a i n t e n a n c e
Owner's Periodic Maintenance Guide
Item:
Process:
When:
Battery Connections
Clean and tighten all battery connections. Follow battery
manufacturer's instructions for cleaning a battery. Clean all
battery terminals with a wire brush where required and tighten
all battery connections.
Monthly
Item:
Process:
When:
Battery Electrolyte
Per battery manufactures instructions monitor and maintain
proper levels of distilled water in each battery.
Monthly
Item:
Process:
When:
ProTournament DC Output Wiring
Visually inspect all wiring for cuts and abrasions. Contact
ProMariner if charger needs to be serviced with new wiring.
Monthly
Item:
Process:
When:
AC Power Cord and Mounting Hardware Inspection
Process: Visually inspect the AC power cord. Confirm ground
blade is present and all plug blades are in good conditions
and not bent out of place.
Check all mounting hardware to ensure there is no loose
hardware. Tighten were required.
Monthly