ProMariner ProSport - Manual (Page 8)

14
13
12
11
14.6V
13.3V
Charging Conditioning Maintenance / Float Mode
Average Voltage
V
o
lts
6
Note: The only LED Indicator that will be on during the maintenance mode will
be the green "Power" LED indicator.
P r o S p o r t O v e r v i e w / I n s t a l l a t i o n G u i d e l i n e s
Installation
All ProSport Battery Chargers are designed to be permanently mounted on-board,
and can be mounted with extruded fins placed vertically or horizontally.
Always mount your ProSport Charger in a compartment area that can be properly
ventilated during use.
Do NOT mix battery types on-board. All batteries should be of the same age
and in good operating condition.
Do NOT make any electrical connections to the ProSport or batteries until the
following steps are completed:
11 Easy to follow installation steps:
1. Select a mounting location that allows for free air ventilation with a minimum of 8 inches
of clear unobstructed space around and infront of the ProSport On-board Marine Battery
Charger. Open all battery and engine compartments and ventilate for at least 15 minutes
before starting the installation of the ProSport Charger.
Multi-Stage Charging Overview Continued
ProSport Float / Maintenance
During this mode the red "Charging" LED will turn off indicating that the charging
process is over and the charger is now maintaining your batteries on-board. Only
the green LED will remain on, indicating Power On / Float-Maintenance mode.
A precision 13.3 volts (lead acid factory setting) finishing voltage that maintains
each battery (step down voltage regulation mode) which is perfect for short or long
storage periods and will never overcharge your batteries.
ProSport Series Wiring Diagrams
9
Engine or Trolling
Motor Battery 3
Trolling Motor
Battery 2
Trolling Motor
Battery 1
+
_
+
_
+
_
AC power
output no.1
output no.2
output no.3
ProSport20 Plus
Wiring Diagram
red red red black or yellow black or yellow black or yellow
I n s t a l l a t i o n G u i d e l i n e s / C h a r g i n g Yo u r B a t t e r i e s
Engine or Trolling
Motor Battery 2
Trolling Motor
Battery 1
+ _ + _
AC power
output no.1
output no.2
ProSport 8, 12 and 20 Wiring Diagram
red black or yellow red black or yellow
Engine or Trolling
Motor Battery 1
+
_
AC power
output no.1
ProSport 6 Wiring Diagram
red black or yellow
Charging Batteries
The ProSport Series is designed to charge, condition and maintain your batteries. Please
follow these steps each time you use your ProSport Charger:
1. Open all battery compartments and ventilate for at least 15 minutes before applying AC
power to your charger. While charging your batteries make sure to keep your battery
compartment open allowing for free air ventilation.
2. Make sure all DC battery connections are tight and clean. Follow battery manufacturer's
recommendations for battery cell caps. (loosen caps if applicable)
C h a r g i n g Yo u r B a t t e r i e s