MadgeTech RFRTDTemp2000A - Manual (Page 9)

RFRTDTemp2000A
External Channel
Temperature Range
-200 °C to +850 °C (-392 °F to +1562 °F)
Temperature Resolution 0.001 °C (0.0018 °F)
Calibrated Accuracy ±0.01 Ω (±0.05 °C)
Response Time 10 minutes free air
Temperature
RF Frequency
2.45 GHz IEEE 802.15.4 ultra-low power wireless transceiver
with fully bi-directional communication
Band
ISM band 2.405-2.475 GHz
Operation (channels 11 through 25) @ 250 kbps
Maximum Output
Power
+0 dBm typical
Receiver Sensitivity
(RFC1000)
-95 dBm typical
Transmission Distance
(to other RFC1000’s)
• RFC1000
4,000 ft max. outdoors - line of sight unobstructed
1,000 ft max. indoors - typical urban environment
• RFC1000-CE
2,500 ft max. outdoors - line of sight unobstructed
700 ft max. indoors - typical urban environment
• RFC1000-IP69K
4,000 ft max. outdoors - line of sight unobstructed
1,000 ft max. indoors - typical urban environment
Transmission Distance
(to data loggers)
• RFC1000, RFC1000-CE & RFC1000-IP69K
2,000 ft max. outdoors - line of sight unobstructed
500 ft max. indoors - typical urban environment
Wireless
Battery Warning
WARNING: BATTERY MAY LEAK, FLAME OR EXPLODE IF DISASSEMBLED, SHORTED, CHARGED, CONNECTED
TOGETHER, MIXED WITH USED OR OTHER BATTERIES, AND/OR EXPOSED TO FIRE/HIGH TEMPERATURE. DISCARD
USED BATTERY PROMPTLY, KEEP OUT OF REACH OF CHILDREN.
Specifications subject to change.
See MadgeTech’s terms and conditions at www.madgetech.com
7
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
To satisfy FCC RF Exposure requirements for mobile and base station transmission devices, a separation distance of 20 cm or more should be
maintained between the antenna of this device and persons during operation. To ensure compliance, operation at closer than this distance
is not recommended. The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
Sensor Type External 100 Ω Resistance Temperature Detector (RTD)
Approvals US (FCC), CA (IC), CE, South Korea (KCC), China (CMIIT), Japan (LCIE)
General Specifications Continued