ATI Technologies ATP 8500 - Manual (Page 27)

Display Setup Menu
• The Display Setup specifies the parameters for
the On Screen Display. In each case you may
use the LEFT and RIGHT keys to alter the
parameter you have selected.
• Select TV System to switch between NTSC and
PAL to suit your TV system.
• Superimpose allows the OSD either to replace
the TV picture (Off) or be superimposed over
it (On).
• During normal operation you can make a
“temporary” OSD appear for a few seconds
every time you do any adjustment. Set this by
using the “Temp. Display” parameter that you
can set to Full, Simple or Off, if you so desire.
• You can set Video Format to S-Video,
Composite or Auto; this will automatically select the best source present.
• You can send the OSD (On Screen Display) either to the Composite or S-Video Monitor outputs or both. You can also
switch it Off.
• OSD style changes the screen text color. We suggest you try only the first 5 styles.
• EXIT returns to the main menu.
Trigger Setup Menu
• The Trigger Setup specifies the parameters for
the DC Trigger outputs. You may set each of
these parameters for “Trig1” which controls the
TRIGGER 1 output and “Trig2” which controls
the TRIGGER 2 and TRIGGER 3 OUTPUTS. Use
the UP and DOWN keys to select the parameter
you wish to change. Use the LEFT and RIGHT
keys to alter the parameter you have selected.
• “Sense” sets which controls activate the trigger
output. Set to Power On to activate the trigger
when switching out of STANDBY (and
de-activate it when returning to STANDBY);
Alternatively you may activate the trigger
output when you select any of the inputs
(Tuner, CD, TV, DVD, SAT, VCR, Aux1, Aux2 or 7.1CH)
• “Polar” sets the polarity of the trigger output. “Posit.” gives a +12V DC output when trigger is active and +0V when
inactive. “Negat.” gives +0V DC output when the trigger is active and +12V DC when the trigger is inactive.
• “Delay” sets a delay between the “sense” signal and the trigger output voltage change. You may set the delay to last
from 1 second to 3 minutes or to “No” position that gives zero delay.
• “Durat" sets the period (duration) when the trigger output is active. You may set the trigger duration last from 10 ms
(milliseconds) to 3 minutes, or to “Infin.” that keeps the trigger active while the “sense” condition prevails.
• EXIT returns to the main menu.
Page 27
Display Setup
TV System: NTSC
Superimpose: On
Temp. Display: Full
Video Format Auto
OSD Output: Both
OSD Style 1
Exit
AN EXAMPLE OF THE DISPLAY SETUP MENU
Trigger Setup
Trig1 sense: Power On
Trig1 polar: Posit.
Trig1 delay: No
Trig1 durat: Infin.
Trig2 sense: DVD
Trig2 polar: Posit.
Trig2 delay: 1 s
Trig2 durat: 30 s
Exit
AN EXAMPLE OF THE TRIGGER SETUP MENU