American Audio CommanderPlus - Manual (Page 15)

COMMANDER PLUS™ CONTROLS AND FUNCTIONS
© American Audio ® - www.americandj.com - Commander Plus™ Instruction Manual Page 15
90,11,12
REAR PANEL
PLUSRP
DIRK ELECTRONIC CORPORATION
SHU P,F YUEN
1/1
LINE 3 LINE 3 PHONO 3 PHONO 3 LINE 5 LINE 5 LINE 4 LINE 4 LINE 2 LINE 2
CH-1 CH-1 CH-2 CH-2 CH-3 CH-3
MASTER MASTER REC REC ZONE 1 ZONE 1
OUTPUT OUTPUT
GND GND
AC INPUT 115/230V AC INPUT 115/230V
FUSE 0.5A,F,250V FUSE 0.5A,F,250V
CAUTION: CAUTION:
ATTENTION: ATTENTION:
DISCONNECT SUPPLY CORD DISCONNECT SUPPLY CORD
BEFORE CHANGING FUSE. BEFORE CHANGING FUSE.
DEBRANCHER AVANT DE DEBRANCHER AVANT DE
REMPLACER LE FUSIBLE. REMPLACER LE FUSIBLE.
CAUTION: CAUTION:
ATTENTION: ATTENTION:
TO REDUCE THE RISK OF FIRE, TO REDUCE THE RISK OF FIRE,
REPLACE ONLY WITH THE SAME REPLACE ONLY WITH THE SAME
TYPE AND RATING OF FUSE. TYPE AND RATING OF FUSE.
UTILISER UN FUSIBLE DE UTILISER UN FUSIBLE DE
RECHANGE DE MEME TYPE. RECHANGE DE MEME TYPE.
AMERICAN AUDIO AMERICAN AUDIO
PREAMP MIXER PREAMP MIXER
MODEL NO. COMMANDER PLUS MODEL NO. COMMANDER PLUS
AC 115/230V ~ 50/60HZ 20W AC 115/230V ~ 50/60HZ 20W
L
R
PAS OUVRIR. PAS OUVRIR.
RISK OF ELECTRIC SHOCK RISK OF ELECTRIC SHOCK
AVIS:RISQUE DE CHOC ELECTRIQUE-NE AVIS:RISQUE DE CHOC ELECTRIQUE-NE
CAUTION CAUTION
DO NOT OPEN DO NOT OPEN
CH-4 CH-4
LINE 6 LINE 6
BALANCED OUTPUT BALANCED OUTPUT LEFT LEFT RIGHT RIGHT
AUX 3 AUX 3
PHONO 2 PHONO 2
AUX 2 AUX 2
PHONO 1 PHONO 1
AUX 1 AUX 1 LINE 1 LINE 1
AUX 1 AUX 1 PHONO 1 PHONO 1 PHONO 2 PHONO 2 AUX 2 AUX 2 PHONO 3 PHONO 3 AUX 3 AUX 3
L
R
GND GND LIGHT CONTROL LIGHT CONTROL
ZONE 2 ZONE 2
SEND SEND RECEIVE RECEIVE
EFFECT EFFECT
MIC 3 MIC 3
PLAYER CONTROL PLAYER CONTROL
A B
41 44
38 40 37
42 43 45 46 47 49 48 50 51 52 53
37 39
FUSE
37. GND (GROUND TERMINAL) - Be sure to connect turntable ground leads to either or both of the
two available ground terminals. This will reduce the humming and popping noises associated with
magnetic phono cartridges.
38. LIGHT CONTROL OUTPUT - This jack provides a preset mono audio output signal. There is
no way to adjust this level, however this level will directly reflect the output level of the CHANNEL
SLIDERS (10). This buffered audio output should only be used with light controllers that can accept
an external audio input signal. This is a great feature for Touch Panels and Chase Controllers, allow-
ing a light show to synchronize with the sound system automatically.
39. PLAYER CONTROL - These jacks are used to control the “Q-Start” function between the mixer
and a compatible American Audio
®
or American DJ
®
CD Player. Input the mini plugs included with
your CD player from CD player controller into these jacks, input CD 1 into jack 1 and CD 2 into jack 2
and so on. Be sure to only use the mono tip mini plugs included with your CD player to avoid damage
to the mixer and/or the CD player.
40. CHANNEL LINE LEVEL SELECTOR SWITCHES - These switches are used to change the volt-
age line levels of there respected Phono / Aux RCA inputs jacks. When connecting turntables with
magnetic cartridges to these jacks be sure the corresponding switch is in the “PHONO” position, and
when using line level input devices be sure this switch is in the “AUX” position. Always be sure main
power is shut off before change the position of the Line Level Selector Switch.
41. AC VOLTAGE SELECTOR - This switch is used to change the operating voltage. Operating volt-
age can be toggled between 120v/50Hz or 220v/50~60Hz. Be sure the selector is set to the proper
voltage for your area before attempting to operate the unit. Always be sure main power is shut off
before change the position of the Voltage Selector Switch.
42. FUSE - This housing stores the 0.5 amp GMA protective fuse. Always replace with the exact
same type fuse, unless otherwise instructed, by an authorized American Audio
®
service technician.
Replacing with any other type of fuse than that of the recommended fuse will void your unit war-
ranty.
REAR PANEL