Dwyer TG - Manual

Series TG Polycarbonate Wall Mount Thermostat Covers
Specifications - Installation and Operating Instructions
Bulletin H-2-TG
The Series TG Polycarbonate Thermostat Cover
prevents physical damage and unauthorized adjustments of
thermostats. Two sizes of covers are available to fit most
common thermostats and transmitters. The low profile
design with ventilation slits allows exceptional air flow in
order to obtain accurate measurements.
TOOLS LIST
Included:
1 Series TG Thermostat Cover
2 Keys
4 Concrete Screws
4 Drywall Screws
4 Plastic Anchors
Tools Required:
Pencil
Hammer
#2 Phillips Screwdriver
5/16˝ (8 mm) nut driver (for concrete screws)
Hand Drill
9/32˝ (7.1 mm) drill bit (drywall screws)
5/32˝ (4 mm) drill bit (concrete screws)
DWYER INSTRUMENTS, INC.
Phone: 219/879-8000 www.dwyer-inst.com
P.O. BOX 373 • MICHIGAN CITY, INDIANA 46361, U.S.A. Fax: 219/872-9057 e-mail: [email protected]
Fig. 1
Mounting Screws, Concrete screw on the left,
Drywall screw on the right.
4.650
[118.1]
MAXIMUM
INTERNAL
FOOTPRINT
6.890
[175]
MAXIMUM
INTERNAL
FOOTPRINT
9.450
[240]
6.650
[168.9]
3.000
[76.2]
2.890
[73.4]
MAXIMUM
INTERNAL
FOOTPRINT
2.000
[50.8]
MAXIMUM
INTERNAL
FOOTPRINT
MAXIMUM
INTERNAL
FOOTPRINT
2.930
[74.4]
4.840
[122.9]
MAXIMUM
INTERNAL
FOOTPRINT
2.125
[53.98]
4.750
[120.7]
6.750
[171.5]
H-2-TG:TEMPLATE 6/4/08 10:18 AM Page 1