BrassCraft 110ES Series - Manual (Page 5)

SPECIAL
APPLICATIONS Reverse Operation
Running this machine in reverse should only be done if the cable
becomes blocked and only for a few seconds, enough to free the
end of the cable. If the cable gets caught on an obstruction,
immediately release the trigger to allow the machine to come to
a complete stop. Fully tighten the chuck and turn the drill switch
to the (REV) position. Grasp the cable with a gloved hand and
pull it while jogging the trigger. When the cable is dislodged,
place the drill switch in the forward (FOR) position, loosen the
chuck, and follow normal operating procedure.
Lubrication
Grease all exposed and moving parts.
Storage
The machine must be kept in a dry, safe place, out of the reach
of children.
Cables
The metal cable should be thoroughly cleaned with water to
prevent unpleasant odors and the damaging effects of drain
cleaning compounds.
CABLE REMOVAL
& REPLACEMENT • The cable is NOT attached to the inside of the auger, so to
REMOVE the cable from the drum, continue to pull the cable
from the drum until it is fully removed from the drum
• To REPLACE the cable, first bend a 45∘angle in the end of the
cable end that goes into the drum
• Continue to push the cable into the drum until complete
Replacement Cable ST-96101G
REPLACING THE
DRILL MOTOR • Remove the three allen bolts from the front cover
• Remove the center hub screw with a slotted screwdriver
(left hand threads)
• Remove the three allen bolts from the drive hub
• Remove the drill from the drive hub