Studio Designs Light Pad Support Bars - Manual (Page 2)

NOTE: If your table is assembled, remove the entire table top including the frame, glass and art trays,
place face down on a clean, soft surface. You may have to drill 7/64” (2.78mm) holes in the Pencil
Ledge (5) and Top Frame (2).
Insert Phillips Screws (B) through holes in Support Brackets (A), Pencil Ledge (5) and Top Frame (2).
NOTE: If your table has not been assembled the following instructions apply:
• After #2 on page 7 in your Vision Craft Station Instruction Sheet, insert Phillips Screws (B) through
holes in Support Brackets (A), Pencil Ledge (5) and Top Frame (2).
B
B
2
5
A A