Studio Designs Light Pad Support Bars - Manual

NOTE: If your table is assembled, remove the entire table top including the Top Frame(3), Glass (14)
and art trays 20 & 21), place face down on a clean, soft surface.You may have to drill 7/16" (2.78mm)
holes in the pencil ledge and table frame.
• Insert Phillips Screws (B) through holes in Support Brackets (A), pencil ledge and Top Frame(3).
NOTE: If your table has not been assembled the following instructions apply:
• Just before STEP 3 in your Futura Craft Station Instruction Sheet, insert Phillips Screws (B) through
holes in Support Brackets (A), and Top Frame(3).
B
B
A
3
21
22
A