Studio Designs Adapta Table - Manual (Page 2)

1.
PLACE TOP (1) ON CLEAN, FLAT SURFACE. ATTACH LEG
FRAMES (2) TO TOP (1) USING ALLEN BOLTS (7). INSERT
LEGS (3) INTO FRAMES AS SHOWN, AND LOCK IN PLACE
WITH ADJUSTMENT KNOBS (6). HEIGHT MAY BE ADJUSTED
AS DESIRED.
NOTICE!
FINGER TIGHTEN BOLTS UNTIL BASE IS ATTACHED TO TOP.
TIGHTEN ALL BOLTS AFTER UNIT IS COMPLETELY ASSEMBLED.
6
4
8
1
7
2
3 5
2.
ATTACH REAR PANEL (4) TO LEG FRAMES USING ALLEN
BOLTS (8) AS SHOWN. INSERT FLOOR LEVELERS (5) INTO
BOTTOM OF LEGS.
ASSEMBLY INSTRUCTIONS
IMPORTANT:
CAREFULLY UNPACK & IDENTIFY EACH COMPONENT BEFORE ATTEMPTING TO ASSEMBLE. REFER TO PARTS LIST.
PLEASE TAKE CARE WHEN ASSEMBLING THE UNIT AND ALWAYS SET THE TABLE TOPS ON A CLEAN, SOFT SURFACE.
ADAPTA
6
4
8
1
7
2
3 5