Ar ch ive d – Seametrics DL75 v.2 User Manual
Page 8
I
nstallatIon
3
Installation
To install FlowInspector:
1. Close all other programs running on your computer.
2. Put the CD-roM in your drive
3. If your computer is not set for autoloading, open the CD
drive and run setup.exe
4. When FlowInspector is finished loading, click Next.
5. Fill in the User Information. Use the serial number from
the CD case. Click Next.
6. Follow the directions to accept or to change the
installation directory location.
7. Select the Setup Type, which is normally Typical.
8. Follow the instructions to select the Program Folder.
9. Click oK when message regarding Palm utilities is
displayed (not needed for v.1.7).
10. Click Finish to complete.
AR
CH
IVE
D
(2/01/08)
See also other documents in the category Seametrics Equipment:
- EX800-Series (12 pages)
- EX100-200-Series (16 pages)
- IP800-Series (12 pages)
- IP100-200-SERIES (12 pages)
- TX800-Series (12 pages)
- TX100-200-SERIES (12 pages)
- PE102 (4 pages)
- SEB (2 pages)
- SES (4 pages)
- S-Series (4 pages)
- MJ-Series (4 pages)
- MJN-Series (4 pages)
- WJ-Series (4 pages)
- WT-Series Turbine (4 pages)
- iMAG-Series (16 pages)
- WMX-Series (12 pages)
- WMX-Series (8 pages)
- WMP-Series (8 pages)
- AG2000-Series (4 pages)
- AO55 (4 pages)
- FT400-Series (12 pages)
- DL76 (4 pages)
- FT500-Series (8 pages)
- FlowInspector (16 pages)
- RSP5 (4 pages)
- PT35 (4 pages)
- PT34 (4 pages)
- PS40 (2 pages)
- PD10 (4 pages)
- PC-SERIES (4 pages)
- AD30 (2 pages)
- AG1000 (10 pages)
- AG2000 v.1 (4 pages)
- AG2000 v.2 (4 pages)
- AO45 (4 pages)
- DL75 v.1 (4 pages)
- EM 100-102 v.1 (4 pages)
- EM 100-102 v.2 (4 pages)
- EM 101 v.1 (6 pages)
- EM 101 v.2 (8 pages)
- EX100-200 Series v.1 (14 pages)
- EX100-200 Series v.2 (16 pages)
- EX80 Series v.1 (12 pages)
- EX80 Series v.2 (12 pages)