Revo REVDN600-2 - Manual (Page 7)

3
INSTALLATION
Figure 1
Torx screws
M5x10 (4x)
Figure 2
Seal around
the housing
base tightly using
the silicon rubber
Figure 3
Drilling
Guide Label
Plastic Anchor(4x)
Rubber Washers(4x)
Mounting Screw
M6X35(4x)
1. Loosen the four torx screws located midway up the front of the housing leave the screws
intact in the front portion. (Fig. 1)
2. Drill the mounting location using the supplied drill guide label. (Fig. 3)
3. Attach the housing to the ceiling using suitable fasteners, M6x35 tapping screws are
supplied only use if they are suitable. (Fig. 3)
4. Closing the housing using the loosen torx screws. (Fig. 2)
CEILING / WALL