Revo R4CH12VAMP - Manual (Page 7)

1. Video OUT
The RJ-11 DVR connector is used to connect a DVR to the Camera for recording
2. DC Power Signal Checker LED
The LED Illuminates "Green" when there is an input 12Vdc Power (From DVR)
The R4CH12VAMP Line Amplifier allows you to transmit video signals over 300ft distances by
amplifying the video signal from the camera to the DVR.
Please read the following instructions to correctly set up your line amplifier.
- Camera signal Checker LED
- Line DC Voltage Checker LED
- 300ft Video & Camera DC Power AMP
FEATURES
OPERATING INSTRUCTION
1. LED
A green indicator lights when the power is ON
2. DC JACK
Place the plug from the supplied table-top power supply into the DC 12V connector.
3. Video Signal Checker LED
The LED Illuminates "Green" when there is an input Video signal (From camera)
4. Camera INPUT
Four cameras can be connected to the AMP using the RJ-11 connections labeled CAM1, CAM2,
CAM3 and CAM4.
Front )
Rear )