Revo RM185-ID1 - Manual (Page 7)

▶
Installation
1. Please turn off the RM185-ID1 before connecting any device to it.
2. Connect adaptor cable to DC power-on on the rear side of
the RM185-ID1 then connect power cord to adaptor.
3. RM185-ID1 has 15pin VGA port.
Connect the cables properly to your DVR between VGA.
4 .Turn on your DVR and RM185-ID1 .
5. Display conditions with can be adjusted by pushing control buttons
on the right side of the RM185-ID1 .
6. At the user's convenience, you can adjust the display angle of
the RM185-ID1 under 25 degree to backward.
7. Please turn off the RM185-ID1 when not in use.
☞ Adjusting LCD panel angle
- Do not hold or press down on the monitor's
screen while adjusting angle since LCD
panel maybe damaged or break if severe.
- Do not lean backward excessively so that
the monitor dose not fall backwards.
- Be careful of potential damage to the stand
while adjusting angle.
25’
5