Installation – Precision Control Systems StripIR 4185 User Manual
Page 12
Installation
• Phillips
Screwdriver
NOTE:
Refer to Figures 4-1 Typical Installation.
Refer to Figure 4-2 Mounting Dimensions.
As shown in Figure 4-1, six 10-32 x 1/2 inch screws are provided on the top of the Model
4185 heater for mounting purposes. The heater can be attached directly to a suitable
frame structure or mounting brackets using these six screws. Mount the heater so that
the intended target absorbs the generated infrared energy yet not so close that the heater
touches the target. The heater should be mounted so that each end cover may easily be
removed for lamp installation.
Multiple Model 4185 heaters can be mounted side-by-side to form large heating arrays.
4-1
Section 4
TOOLS REQUIRED
MECHANICAL
INSTALLATION
Figure 4-1: Typical
Installation for Model 4185
Heater