NSi Industries E120B - Manual (Page 5)

PROGRAMMING YOUR E101B / E103B / E120B
NOTE: AFTER MAKING ANY CHANGES TO THE
PROGRAM, PRESS MODE TO GO TO RUN
MODE AND THEN PRESS EVENT TO UPDATE
THE LOAD STATUS.
AT POWER UP:
When powering up the unit for the first time, the
display will show E1 60 r - 0A, then 12:00 will flash
on the display. NOTE: Allow 1-2 minutes for the
supercap to charge before any display is shown.
Press the MODE key to go to the CLK mode. After
pressing the MODE key the display will show:
1.0 TO SET CLOCK
Press HOUR and MIN to advance to the present
hour and mins. Check AM/PM, and press ENTER.
1.1 TO MODIFY CLOCK
Press MODE until the display shows: CLK. Press
HOUR and MIN. to modify clock and press
ENTER.
2.0 TO SET DATE
If you are setting for the first time, display will
show:
3
MO TU WE TH FR SA SU ASTRO
CH1 MOM AM PM OFFSET CH2
CLK DATE SCH AUTO MAN
MO TU WE TH FR SA SU ASTRO
CLK DATE SCH AUTO MAN
E101B SINGLE 7/22/07 10:02 PM Page 5