NSi Industries DZS400BP - Manual (Page 9)

If an offset to sunrise time is required, press HOUR
and MIN. Offset can be set to 4 hours and 59 min-
utes max. Press EVENT to select + or – and then
press ENTER.
NOTE: A + sign will turn load OFF that many hours
and/or minutes after sunrise. A - sign will turn load
OFF that many hours and/or minutes before sun-
rise.
8.2 ASTRONOMIC ON AND TIME OFF
Set astronomic ON per sections 8.0 and 8.1
TIME OFF:
Press MODE until “sch01” appears. Press ENTER
until a blank schedule appears then press SELCT
to select desired channel. Press HOUR and MIN to
set desired OFF time. Press SELCT to select
desired days, holiday and/or seasons and then
press ENTER.
8.3 TIME ON AND ASTRONOMIC OFF
Press MODE until “sch01” appears. Press ENTER
until a blank schedule appears then press SELCT
to select desired channel. Press HOUR, MIN and
EVENT to set desired ON time. Press SELCT to
select desired days, holiday and/or seasons and
then press ENTER.
ASTRO OFF:
Set astronomic OFF per sections 8.0 and 8.1
9.0 REVIEW, MODIFY AND DELETE
Press MODE to advance to any of the following
MODES:
1.
CLOCK MODE: Press HOUR and MIN to mod-
ify existing settings. Press ENTER.
2. DATE MODE: Press M O N T H, DAT E a n d
Y E A R to modify existing settings. P r e s s
ENTER. DAY is automatically adjusted.
3. DST Daylight Saving Time: To review press
ENTER. To modify press MONTH, DATE and
DAY to change existing setting. Press ENTER.
4. SEASON MODE: Press ENTER to advance to
desired season. Press MONTH and DATE to
modify, DEL to delete. Press ENTER to con-
firm.
10
Press MONTH and DATE to set holiday 1 and then
press ENTER. The display will show:
To delete any holiday press DEL and press
ENTER.
NOTE:
a. A total of 24 holidays can be set, all following
the same schedule.
b. For any holiday to be used, the MONTH and
DATE must be preset.
6.0 TO SET SIGNAL DURATION FOR EACH
C H A N N E L
Press MODE until display shows:
Press SELCT to select desired channel. Press
EVENT/SEC to set desired signal duration (1 to 99
seconds each), and then press ENTER.
NOTE:
a. Use the procedure above to set signal duration
for signal 2 or to set signal duration for other
channels if desired.
b. Each channel can have two independent dura-
tions (sig 1 and sig 2).
7.0 SCHEDULE SET MODE
Press MODE until display shows:
Press SELCT to select desired channel.
7
DTS400B - DZS400BP 3/9/07 10:18 AM Page 17