Troubleshooting, Installation environment, Installation procedure – NOSHOK 1900 Series Micro-Line Power Supply User Manual

Page 2

TROUBLESHOOTING

For further technical assistance, please contact us.

Corporate Headquarters

1010 West Bagley Road
Berea, Ohio 44017
Ph: 440.243.0888
Fax: 440.243.3472
E-mail: [email protected]
Web: www.noshok.com

INCORPORATED

TMDIP04-1

INSTALLATION ENVIRONMENT

The unit should be installed in a location that does not exceed the maximum

operating temperature and provides good air circulation. Placing the unit near
devices that generate excessive heat should be avoided.

Installation Procedure

These power supplies are shipped with all of the necessary hardware to
mount to the rear of an installed Micro-Line unit. Refer to the instructions
that correspond to your Micro-Line unit for proper installation.

1900 INDICATOR

The user must remove the common and V+ screw terminals
on the rear of the Micro-Line unit. Install the 1/4” hex
drive stand-offs into the common and V+
terminals. The power supply is then mounted
to the stand-offs using the screw terminals
and square washers. AC power can then be
connected to the terminal block of the
power supply.

1950 INDICATOR

The user must remove the common and V+ screw terminals
on the rear of the Micro-Line unit. Install the 3/16” hex
drive stand-offs into the common and V+
terminals. The power supply is then mounted
to the stand-offs using the screw terminals
and square washers. AC power can then be
connected to the terminal block of the
power supply.

BEZEL

GASKET

STAND-OFF (2 TYP)

EXISTING PANEL

MOUNTING CLIP

SQUARE
WASHER

SCREW TERMINALS