Martel Electronics BETA LDT-500 - Manual (Page 2)

0219872 Rev B 12/11
Martel Electronics Corporation
3 Corporate Park Drive, Unit # 1
Derry, NH 03038
www.martelcorp.com • e-mail: [email protected]
Tel: (603) 434-1433 • 800-821-0023
Fax: (603) 434-1653
4. If moisture or dirt particles are seen within the clear chamber during
use, dismantle and clean the trap.
Cleaning/Assembly:
1. Unscrew the top section of the LDT-500 then remove the clear acrylic
chamber and the two o-rings.
2. Clean and dry the internal components with a clean cloth. DO NOT USE
SOLVENTS on the clear acrylic chamber as damage may occur.
3. Before reassembly inspect the clear acrylic chamber, external and inter-
nal o-rings for wear or damage and repair by ordering replacement
parts. Do not reuse worn or damaged parts.
4. Before assembly lightly lubricate the two internal o-rings with Dow 111,
or silicone grease and then reassemble the LDT-500 properly. Hand
tighten only.