KROHNE M10 Converter HART 0201 - Manual (Page 7)

KROHNE Messtechnik GmbH & Co. KG · Ludwig-Krohne-Str. 5
§
D-47058 Duisburg 7/15
Tel.: 0203-301 0
§
Fax: 0203-301 389 · e-mail: [email protected]
Remote Operation Instructions M10 HART
Attachment B
M10 Menu Tree AMS
• Flow
• Flow, scaled by URV/LRV
• Flow, scaled by USL/LSL
• Positive Totalizer
• Current Output
• Flow, Percent Range
Process Variables
Status
Scan Device
-----------------------------------
Diagnostics and Test
Calibrate
-----------------------------------
Error reset
Counter reset
Master reset
-----------------------------------
Assign
Unassign
Rename
-----------------------------------
Audit Trail
Record Manual Event
Drawing Notes ...
Help ...
-----------------------------------
Clear Offline Configuration
Compare Configurations
Configuration Properties
Overview
• Primary variable out of limits
• Non-primary variable out of limits
• Primary variable analog output saturated
• Primary variable analog output fixed
• Cold start
• Configuration changed
• Field device malfunction
• Output has no TK Correction
• Output is not Linear
• Counter is stopped
• Not Table is valid
• New Table bad, use old Table
• Table under Configuration
• Conflict between unit system and unit code
• Too few linearization points
• Linearization values in table not monoton
increasingt
• X-Values for first table index is not 0%
• X-Values for last table index is not 100%
– refer to the next page.
Errors
Designations:
• B1 is inactive
• B1 is set to flow
• Flow > Flowlimit
• Flow < Flowlimit
• B1 is set to counter
• Counter value bigger than switchpoint
• B2 is used as pulse output
• B3 is inactive
• B2 is inactive
• B2 is set to flow
• Flow > Flowlimit
• Flow < Flowlimit
• B2 is set to counter
• Counter value bigger than switchpoint
Warnings
KROHNE M10 45ea0201