KROHNE SMARTSENS PH 8xxx Ex EN - Manual (Page 10)

3
INSTALLATION
10
SMARTSENS PH 8XXX
www.krohne.com 07/2014 - 4002951402 - MA SMARTSENS PH 8xxx R02 en
Installation
3.1 Installation
Mounting of the sensor
• Ensure that you use a gasket suitable for the dimensions of the process connection and the
requirements of the measuring point.
• Align the gasket correctly.
• Carefully lower the sensor into the provided assembly and afterwards into the tank or the pipe.
• Observe all the relevant regulations.
DANGER!
The manufacturer is not liable for any damage or injuries resulting from improper use or use
other than the intended purpose. This applies in particular to hazards due to insufficient
corrosion resistance and suitability of the materials in contact with product.
DANGER!
Installation and setup must be carried out according to the applicable installation standards (e.g.
EN 60079-14) by qualified personnel trained in explosion protection. Observe the information
contained in the manuals and the supplementary instructions. The installation must always
comply with the following requirements:
• No external forces are affecting the sensor.
• The device is accessible for any necessary visual inspections and can be viewed from all
sides.
• The nameplate is clearly visible.
• All gaskets are suitable for the intended use.
.book Page 10 Monday, July 21, 2014 3:08 PM