KROHNE BM 100 HART - Manual (Page 9)

BM100 Remote Operation - HC 275 / AMS
Dev.-Rev. EE, DD-Rev. 03
© 2000 KROHNE Meßtechnik D-47058 Duisburg Page 9
Attachment B
Designations:
Measurements
•
Level
•
Distance
•
Volume/Mass
•
Interface Level
•
Interface Distance
•
Interface Volume/Mass
•
Ullage Volume/Mass
•
Interface Layer
Process Variables
Status
-----------------------------------
Diagnostics and Test
Calibrate
-----------------------------------
Master reset
Reset user EEPROM
Reset factory EEPROM
-----------------------------------
Entry Code
Service Code
-----------------------------------
Audit Trail
Drawing Notes ...
Help ...
-----------------------------------
Clear Offline Configuration
Compare Configurations
Configuration Properties
Overview
•
Primary variable out of limits
•
Non-primary variable out of limits
•
Primary variable analog output saturated
•
Primary variable analog output fixed
•
Cold start
•
Configuration changed
•
Field device malfunction
Fatal errors
•
ADC reference error
•
ROM checksum error
•
RAM read/write error
•
EEPROM factory error
•
EEPROM user error
•
DAC error
•
Strap table error
- subsists and is displayed only when the Strap Table exists
- subsists and is displayed only when ‘Interface Option’ is enabled
- refer to the next page
Errors
Signal errors
•
Microwave error
•
No end of scan pulse
error
•
No reference pulse error
•
No level pulse error
•
No interface pulse error
•
Dead zone error
•
Signal reference pulse
•
No level pulse
•
Level frozen
•
No interface level pulse
•
Interface frozen
Warnings
BM100 Menu Tree AMS
KROHNE BM100 45f9ee03
Analog Outputs
•
Analog Output 1 Value
•
PV Percent of Range
•
Analog Output 2 Value
•
SV Percent of Range
Calibration Management
-----------------------------------
D/A trim
Apply values
-----------------------------------
Linearity calibration
Measure pulses
-----------------------------------
Level threshold/gain
Interface level threshold/gain
Reference threshold/gain
-----------------------------------
Distance input
Interface distance input
-----------------------------------
Strap table input
Strap table suppress
Loop test