KROHNE IFC 070 Converter EN - Manual (Page 15)

ELECTRICAL CONNECTIONS
4
15
IFC 070
www.krohne.com 04/2009 - 4000572101 - TD IFC 070 R02 en
4.1 Safety instructions
4.2 Installation of converter
• Mount converter with mounting plate on wall or standpipe.
• Keep distance between sensor and signal converter as short as possible.
• Observe length of the delivered signal cable.
4.3 Grounding
All work on the electrical connections may only be carried out with the power disconnected. Take
note of the voltage data on the nameplate!
Observe the national regulations for electrical installations!
Observe without fail the local occupational health and safety regulations. Any work done on the
electrical components of the measuring device may only be carried out by properly trained
specialists.
Look at the device nameplate to ensure that the device is delivered according to your order.
Check for the correct supply voltage printed on the nameplate.
Only applicable for remote versions.
Figure 4-1: Grounding