KROHNE OPTISWITCH 3100C Relay EN - Manual (Page 19)

6 Set up
6.1 General
The numbers in brackets refer to the following illustrations.
On the electronics module you will find the following indicating
and adjustment elements:
l
Potentiometer for switching point adaptation (1)
l
DIL switch for mode adjustment - min./max. (2)
l
Signal lamp (5)
Note:
As a rule, always set the mode with mode switch (2) before
starting the setup of OPTISWITCH 3100 C. The switching
output will change if you set the mode switch (2) afterwards.
This could possibly trigger other connected instruments or
devices.
6.2 Adjustment elements
3
4
5
1
2
Fig. 12: Oscillator WE60R - Relay output
1 Potentiometer for switching point adaptation
2 DIL switch for mode adjustment
3 Ground terminal
4 Screwed terminals
5 Control lamp
Function/Configuration
OPTISWITCH 3100 C - with relay output 19
Set up
29953
-EN
-060830